Customer Rating : 
List Price : $29.99 Price : $21.03
List Price : $29.99 Price : $21.03
Product Description
Cooler Master Hyper 212 Plus RR-B10-212P-G1 120mm Sleeve CPU Cooler
- Computer aided heat sink design provides fin optimization with perfect balance between high and low speed operation.
- Fan mounting using clips for easy installation and swapping Versatile all-in-one mounting solution for Intel Socket.
- Intel LGA1366/ 1156/ 1155/ 775; AMD AM3/ AM2/ AM2.
- Material: Aluminum Fin, w/ 4 heat pipes Connector: 4pin.
- Phenom II X4/ Phenom II X3/ Phenom X4/ Phenom X3/ Athlon X2/ Athlon/ Sempron.
Cooler Master Hyper 212 Plus 120mm Sleeve CPU Cooler, RR-B10-212P-G1 Reviews
Cooler Master Hyper 212 Plus 120mm Sleeve CPU Cooler, RR-B10-212P-G1 Reviews
| 65 of 67 people found the following review helpful:  A must have!, By V. Argo (New York) - See all my reviews Amazon Verified Purchase This review is from: Cooler Master Hyper 212 Plus 120mm Sleeve CPU Cooler, RR-B10-212P-G1 (Personal Computers) The Hyper 212+ is a must-have heatsink for your CPU if you do not wish to pay for pricy water cooling. -Price Only $30, when most high-end heatsinks are priced at $50+ on NewEgg. If you want your CPU to run cooler for a cheap price, the Hyper 212+ is perfect. -Instructions The manual has two to three pictures each step, along with the most minimal of a sentence that describes what the pictures want you to do. You're better off watching the youtube video that Cooler Master uploaded. -Installation Once again, I strongly advise just throwing out the given instructions and view the video that Cooler Master has uploaded to youtube. Installing was a bit tricky at first, one of the nuts refused to go the entire length of the screw, needed pliers to force it the rest of the way. After attaching the backplate, the rest of the process went very smooth. -Performance I installed this heatsink to a week-old i5 750 CPU. Temps were... Read more 37 of 38 people found the following review helpful: OVERCLOCKER MUST BUY!!!!, By R. Gatdula "Tokwa" (Miami, Fl) - See all my reviews Amazon Verified Purchase This review is from: Cooler Master Hyper 212 Plus 120mm Sleeve CPU Cooler, RR-B10-212P-G1 (Personal Computers) I stumbled upon this item on accident. I was originally looking at the OCZ Vendetta II but decided to pick this up instead because it was $7 cheaper, excellent online reviews, and future-proof ability. Installation was a hastle because once more I had to remove motherboard from the CoolerMaster 690, but I enjoy the peace of mind with a well mounted hefty heatsink vs the push pins used by other heatsinks of the same proportions. I have yet to take advantege of using dual 120mm fans, the factory fan seems to be suffice to keep my 3.75Ghz 1.36vcore e5200 consistant at 52C 24hrs on prime95. I cannot distinguish between the noise of this and the three other stock fans in my case except for my XFX9800GT's factory fan. I will recommend this to any enthusiast and even lable the product a "must have". I am looking forward to mounting this on a future planned socket 1366 or 1156. Have a good day. 10 of 10 people found the following review helpful: Quiet and effective, This review is from: Cooler Master Hyper 212 Plus 120mm Sleeve CPU Cooler, RR-B10-212P-G1 (Personal Computers) This is a great CPU cooler for the price. I can push my i5-750 to 4 GHz while keeping temperatures around 60C. I've chosen to throttle it back to 3.6 GHz for 24/7 usage so I can run at a more modest 1.3V and keep the fan at 80% where it's nearly inaudible. The sites that test lots of CPU coolers have shown this to have good cooling and noise performance. My Gigabyte motherboard doesn't offer much control over the fan speed so I'm using the free SpeedFan program to control the speed for different temperature levels. At idle the processor is 38C and the fan is set to a silent 70%. At full load the processor is 53C and the fan is barely audible at 80%. I like my computer to be quiet. The mounting bracket is a bit fussy but I had it mounted in 10 minutes or so. It has a backplate which is a good thing because it allows a tighter clamp and puts less stress on the motherboard. I'm cheap and I used the thermal paste that came with it. |
› See all 378 customer reviews...
No comments:
Post a Comment